Inorganic Mica - Uses 100 percent inorganic Mica as insulating material, eliminating potential carbon contaminates found in most Mica binding agents. This allows MAX2000 heaters to operate at higher temperatures and watt densities.

High Torque Post Terminals - Standard post terminals feature unique posi-weld construction, which allows the terminal to be over tightened without damaging or severing the resistance wire post connection.

High temperature Lead Wire - MAX2000 Mica insulated heaters feature 850 degrees F (450 degrees C) lead wire. This higher temperature rating prevents premature failure where the leads are connected to the heater. 250 degrees C lead wire is also available upon request.

MAX2000 heaters can be custom made to fit your applications. Holes, cutouts and custom features are designed and manufactured to your requirements.

• Volts - 12-575 V Maximum
  

• Watts - 5-80 watts per square inch is recommended for strip heaters. Higher watt densities may be achieved depending on the application and operating temperature of the heater.

• Sheath - Aluminized steel is standard. An optional stainless steel sheath is recommended for temperatures above 750 degrees F.
  

• Resistance Tolerance - Nema standard +10%, -5%
  

• Wattage Tolerance - Nema standard +5%, -10%
  

• Length Tolerance - Up to 24" +/- 1/16" (over 24" +/- 1/8")
  

• Width Tolerance - +/- 1/16"
  

• Standard Band Heater Gap - 3/8"
  

• Width Minimum - 5/8" +/- 1/16"